Versions Compared

Old Version 48

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version 49

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Overshoot on Non-Blade Cartridges

  • If the Overshoot of the Non-Blade Tool is applied Too Long, Decrease the Overshoot.

  • If the Overshoot of the Non-Blade Tool is applied Too Short, Increase the Overshoot.

Expand
titleHow to Select the Bevel Type to Edit

Select desired Cartridge Tab. 

Select the desired Bevel Type from Current Bevel Type.

Edit the desired Configuration field.

Expand
titleHow to Adjust the Overshoot

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

Image RemovedImage AddedImage Added

Tool Line Too Long

  • If the Overshoot of the Non-Blade Tool is applied Too Long, Decrease the Overshoot.

Expand
titleOvershoot General Definition

The Overshoot controls how far past the end of the Line/Arc Segment to apply the Non-Blade Tool.

If the Overshoot of the Non-Blade Tool is applied Too Long, Decrease the Overshoot.

This is similar to the Overcut used with the Blade cartridges.

Expand
titleHow to Adjust the Overshoot

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

...