Page Comparison

Click on the design to select it.

Check the Auto Offset checkbox.  

Enter the distance to move the design in the X Origin field; the Y Origin field uses the same numerical value. 

It will move the lower left corner of the design to the new X/Y Position and it will display Dodge on the bottom of the screen.

This feature is also turned on by selecting Full from the Outside Cut Options dropdown control.

Click on the design to select it.

Uncheck the Auto Offset checkbox.

The design will no longer be offset and will cut the design normally unless values have been entered in the X Origin and Y Origin fields as described above.

This is useful when cutting the opening from a pre-cut sheet matboard and not cutting the outside.