Page Comparison

Select desired Cartridge Tab. 

Select the desired Bevel Type from Current Bevel Type.

Edit the desired Configuration field.

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

The Overcut controls where the cartridgeRetracts from the Matboard.the BladeRetracts from the Matboard (not the Fallout) on the Exterior cuts of Openings. The initial plunge position is determined by the bevel type.

• The Exterior Cut is where the Blade Plunges or Retracts from the Matboard (not the Fallout).  

• If the Overcut is cut Too Long, Decrease

the Exterior

• the Overcut.

• If the Overcut is cut Too Short, Increase the Overcut.

• The Overcut field is marked with a Red Arrow on the Configuration screen and the Mapillustration.

See: Overcut for Creases Configurations

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

The Overcut controls where the cartridgeRetracts from the Matboard.the BladeRetracts from the Matboard (not the Fallout) on the Exterior cuts of Openings. The initial plunge position is determined by the bevel type.

• The Exterior Cut is where the Blade Plunges or Retracts from the Matboard (not the Fallout).  

• If the Overcut is cut Too Long, Decrease the Overcut.

• If the Overcut is cut Too Short, Increase the

Exterior

• Overcut.

• The Overcut field is marked with a Red Arrow on the Configuration screen and the Mapillustration.

See: Overcut for Creases Configurations

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.