Page Comparison

• If the Overcut is Too Long, Decrease the Exterior Overcut.

• If the Overcut is Too Short, Increase the Exterior Overcut.

Select desired Cartridge Tab. 

Select the desired Bevel Type from Current Bevel Type.

Edit the desired Configuration field.

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

• If the Overcut is Too Long, Decrease the Exterior Overcut.

The Overcut controls where the cartridgeRetracts from the Matboard.

If the Overcut is Too Long, Decrease the Exterior Overcut.

The Overcut field is marked with a Red Arrow on the Configuration screen and the Map illustration.

Image ModifiedImage Modified

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

• If the Overcut is Too Short, Increase the Exterior Overcut.

The Overcut controls where the cartridgeRetracts from the Matboard.

If the Overcut is Too Short, Increase the Exterior Overcut.

The Overcut field is marked with a Red Arrow on the Configuration screen and the Mapillustration.

Image ModifiedImage Modified

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.