Page Comparison

• If the Interior Overcut is cut Too Long, Decreasethe Interior Overcut.

• If the Interior Overcut is cut Too Short, Increase the Interior Overcut.

Select desired Cartridge Tab. 

Select the desired Bevel Type from Current Bevel Type.

Edit the desired Configuration field.

Cutting from the Front will cut with the face of the mat toward the operator, and can be selected on the Cutting Preview.

Configurations cut from the Back will only display the bevel type name with no further label; i.e., Normal Bevel.

If you are cutting an element that must be applied to the front of the mat, such as a V-Groove or Pen design, any openings on that layer will also cut from the front and use the Front of Mat configuration item; i.e., Normal Bevel - Front of Mat.

So if you are having problems with a Normal Bevel cut on the same layer as a V-Groove, make sure you select Normal Bevel-Front of Mat to edit the configurations for that opening.  

Image Modified

Image Modified

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

• If the Interior Overcut is cut Too Long, Decreasethe Interior Overcut.

The Interior Overcut controls where the Blade Retracts from the Fallout (not the Matboard) on the Interior cuts of Openings.

The Interior Cut is where the Blade Plunges or Retracts from the Fallout (not the Matboard).  

If the Interior Overcut is cut Too Long, Decreasethe Interior Overcut.

The Interior Overcut field is marked with a White Arrow on the Configuration screen and the Map illustration.

Image ModifiedImage Modified

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

• If the Interior Overcut is cut Too Short, Increase the Interior Overcut.

The Interior Overcut controls where the Blade Retracts from the Fallout (not the Matboard) on the Interior cuts of Openings.

The Interior Cut is where the Blade Plunges or Retracts from the Fallout (not the Matboard).  

If the Interior Overcut is cut Too Short, Increase the Interior Overcut.

The Interior Overcut field is marked with a White Arrow on the Configuration screen and the Mapillustration.

Image ModifiedImage Modified

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.