Page Comparison

Click the Cut Outside toggle On to cut the outside of the mat.

The outside of the mat will now cut. 

Click the Cut Outside toggle Off to not cut the outside of the mat.

The outside of the mat will not be cut.

Optionally, the Outside cut can be turned on or off from the Advanced Outside Options: Enable Outside Cut toggle for the CMC Z1

, Z(9000z), 9000 and 8000+.

Click on the design to select it.

Check the Auto Offset checkbox.  

Enter the distance to move the design in the X Origin field; the Y Origin field uses the same numerical value. 

It will move the lower left corner of the design to the new X/Y Position and it will display Dodge on the bottom of the screen.

This feature is also turned on by selecting Full from the Outside Cut Options dropdown control.

Click on the design to select it.

Uncheck the Auto Offset checkbox.

The design will no longer be offset and will cut the design normally unless values have been entered in the X Origin and Y Origin fields as described above.

This is useful when cutting the opening from a pre-cut sheet matboard and not cutting the outside.

Click on the design to select it.

Click Options > Cut Outside to cut the outside of the mat.

It will now cut the outside of the mat.