Page Comparison

Align the Head Button on the 9000/8000/

8000 RC

8000RC/8000+

Click the Align the Head button to Align the Head into the cutting position and power up the motors in preparation of cutting a mat.

Info
Aligning the Head will only get the machine ready to cut, but not actually cut.

Info
NOTE: The hardware photos below may slightly differ from your specific model but the steps are still the same.

Image Modified

Optionally, if you click the Cut button when the motors are disengaged, it will prompt you to Align the Head.
After the Head is Aligned, itwill then Cut the mat.

Image Modified

Aligning the Head on the CMC 9000/8000/8000 RC/8000+ When Motors are Disengaged
Rotate the Footblock into the 12 O’Clock position.	Image Modified
Holding it about an inch above the bottom rail, slide the Gantry and the Head assembly to the left edge of the CMC until it stops.	Image Modified
It will stop against the Magnetic Stop.	Image Modified
Then slide the Head down until the Footblock rests against the Head Alignment Stop.	Image Modified
Click the Align the Head button or click the Cut button to finish the Align the Head sequence.	Image Modified
Click Continue on the Align the Head screen.	Image Modified
Head will align to the Home position.	Image Modified
If you clicked the Align the Head button, the CMC is now aligned and ready to cut. If you clicked the Cut button, the CMC will now begin to cut the mat.	Image Modified

Info
Use the Disengage button to cut the power to the motors of the cutting Head.

Click the Disengage button to disengage power to the motors of the cutting Head on the CMC.
User will be prompted to Click OK to release the motors.
Grasp the Head and then Click OK.
The motors will be disengaged and the Head will drop. When the motors are disengaged, the Head and the Gantry can be moved freely by hand.
The Head will need to be Aligned again before the next mat is cut.

Image Modified