Page Comparison

Placing Matboard When Cutting from the Back

Info
When the Cutting Preview screen indicates that the current layer is to be cut from the Back of the mat, this also determines how to place the matboard onto the CMC.

Have Two Layers of adequate size of disposable matboard under the Mat to be Cut; a Layer can be temporarily removed when cutting thicker matboard.
Place the matboard into the left corner of the CMC, making sure that the matboard nestles tightly into the Horizontal and Vertical Clamps.

Expand

title	Cut From the Back Definition

Cutting

From

from the Back

will

will cut with the

face

back of the mat toward the

CMC Board

operator, and can be selected on the Cutting Preview.

Configurations cut from the Back will only display the bevel type name with no further label; i.e., Normal Bevel.

If you are cutting an element that must be applied to the front of the mat, such as a V-Groove or Pen design, any openings on that layer will also cut from the front and use the Front of Mat configuration item; i.e., Normal Bevel-Front of Mat.