Disabling the Auto Offset will cut the design normally without being offset into the mat on the CMC Z1 and Z (9000z).
Click on the design to select it.
Uncheck the Auto Offset checkbox.
The design will no longer be offset on the CMC Z1 and Z (9000z) and will cut the design normally unless values have been entered in the X Origin and Y Origin fields as described above.
This is useful when cutting the opening from a pre-cut sheet matboard and not cutting the outside.
Info
Note: The outside cut is shown here merely for visual reference of where the pre-cut matboard will be positioned on the board. This feature can also be used to move the design to avoid flaws in the matboard.
Expand
title
Enable Auto Clamp Offset Definition
The Auto Offset moves the design up and over on the Cut Preview to avoid the Clamparea.
This is for the CMC Z1 and Z (9000z) to overcome the Border Limitation of 1.25"/3.2 cm on the Cut Preview.
This is similar to the Rail Dodge used on the CMC 9000/8000.