Page Comparison

Note: Decreasing the air pressure will decrease the blade depth.

• FrameShop will prompt for a head pressure change only if the current mat is a different setting than the previously cut mat.

• All designs come to the Cut Preview with Dense unchecked on the Cut Speeds screen.

• Returning to the editor then going to the Cut Preview resets the layers to typical matboard with Dense unchecked.

• Click Cut to cut the mat and Align the Head if requested.

• The Head plunges at the home position and applies the current pressure and displays a prompt to adjust the head pressure to the low setting.

• Pull out the air regulator pressure knob by pulling it to the left.

• Turn the air regulator pressure knob counter-clockwise until the marker on the gauge is at the low setting.

• Make sure the gauge does not go below 30 psi.

• Push the air regulator pressure knob back in by pushing it to the right.

• Click OK to cut the mat with this setting.