Page Comparison

The Oval Rotation controls for Feathersor Bumpson an Oval Opening.

A Bump in an Oval Openingis a Lumpof material left behind where the cut started and ended.

If the Oval Opening has a Bump, IncreasetheOval Rotation.

The Oval Rotation controls for Bumps or Feathers on an Oval Opening.

Image AddedImage Added

See: Oval Rotation Configurations

See: Oval Rotation for Openings Configurations

See: Oval Rotation for Drops Configurations

See: Oval Rotation for the Outside Configurations

See: Outside Oval Rotation for V-Grooves Configurations

See: Inside Oval Rotation for V-Grooves Configurations

A Bump in an Oval Openingis a Lumpof material left behind where the cut started and ended.

If the Oval Opening

A Bump in an Oval Outsideis a Lumpof material left behind where the cut started and ended.

If the Oval Outside has a Bump, IncreasetheOval Rotation.

The Outside Oval Rotation for V-Grooves controls for Bumpsor Featherson

A Bump in the Outside cut of an Oval V-Groove is a Lump of material left behind where the cut started and ended on the Outside cut of the Oval V-Groove.

If the Outside cut of the Oval V-Groove cuts with a Bump,

The Inside Oval Rotation for V-Grooves controls for Bumpsor Featherson the Inside Cut of an Oval V-Groove.

A Bump in the Inside cut of an Oval V-Groove is a Lump of material left behind where the cut started and ended on either the Inside Cut of the Oval V-Groove.

If the Inside cut of theOval V-Groove cuts with a Bump, Increase the Inside Oval Rotation.

Image AddedImage Added

See: Inside Oval Rotation Configurations for V-Grooves

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.