Versions Compared

Old Version 45

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version 46

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Cartridges Involved

This Configuration element involves the following Cartridges.

Info

Note: Not all cartridges are available for all CMC models.

Editing the Exterior Overcut on Creases

Expand
titleExterior Overcut Definition

The Exterior Overcut controls where the Blade Retracts from the Matboard (not the Fallout) on the Exterior cut.

The Exterior Overcut field is marked with a Red Arrow on the Configuration screen and the Map illustration.

If the Exterior Overcut is cut Too Long, Decrease the Exterior Overcut.

If the Exterior Overcut is cut Too Short, Increase the Exterior Overcut.

Selecting the Crease Exterior Backup Overcut in the Configurations

Adjusting
Expandtip
title
How to Adjust the Exterior Overcut

When adjusting Configurations, click the Plus

/Minus

(Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.

Crease Exterior Overcut Too Long

Problem:

Panel
panelIconIdatlassian-note
panelIcon:note:
bgColor#B3F5FF

  • Exterior Overcut cuts Too Long.

Resolution:

Panel
panelIconIdatlassian-note
panelIcon:note:
bgColor#B3F5FF
Expand
titleExterior Overcut Definition

The Exterior Overcut controls where the Blade Retracts from the Matboard (not the Fallout) on the Exterior cut.

The Exterior Overcut field is marked with a Red Arrow on the Configuration screen and the Map illustration.

If the Exterior Overcut is cut Too Long, Decrease the Exterior Overcut.

If the Exterior Overcut is cut Too Short, Increase the Exterior Overcut.

Crease Exterior Overcut Too Short

Problem:

Panel
panelIconIdatlassian-note
panelIcon:note:
bgColor#B3F5FF

  • Exterior Overcut cuts Too Short.

Resolution:

Panel
panelIconIdatlassian-note
panelIcon:note:
bgColor#B3F5FF
Expand
titleExterior Overcut Definition

The Exterior Overcut controls where the Blade Retracts from the Matboard (not the Fallout) on the Exterior cut.

The Exterior Overcut field is marked with a Red Arrow on the Configuration screen and the Map illustration.

If the Exterior Overcut is cut Too Long, Decrease the Exterior Overcut.

If the Exterior Overcut is cut Too Short, Increase the Exterior Overcut.