Versions Compared

Version Old Version 36 New Version 37
Changes made by

dani.simmonds

dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Cartridges Involved

This Configuration element involves the following Cartridges.

Info

Note: Not all cartridges are available for all CMC models.

Adjusting the Exterior Overcut

To adjust, click Plus/Minus on the desired field about five times.

Exterior Overcut on Creases Definition

Tip

  • Click OK and do another test cut.

  • Continue making adjustments until the desired outcome is achieved.

    • Expand
    titleExterior Overcut Definition

    The Exterior Overcut controls where the Blade Retracts from the Matboard (not the Fallout) on the Exterior cut.

    The Exterior Overcut field is marked with a Red Arrow on the Configuration screen and the Map illustration.

    If the Exterior Overcut is cut Too Long, Decrease the Exterior Overcut.

    If the Exterior Overcut is cut Too Short, Increase the Exterior Overcut.

    Adjusting the Exterior Overcut

    Tip

    • To adjust, click Plus/Minus on the desired field about five times.

    • Click OK and do another test cut.

    • Continue making adjustments until the desired outcome is achieved.

    Current Crease Bevel Type

    Tip

    • Crease

    Crease Exterior Overcut Too Long

    Problem:

    Panel
    panelIconIdatlassian-note
    panelIcon:note:
    bgColor#B3F5FF

    • Exterior Overcut cuts Too Long.

    Resolution:

    Panel
    panelIconIdatlassian-note
    panelIcon:note:
    bgColor#B3F5FF
    Expand
    titleExterior Overcut Definition

    The Exterior Overcut controls where the Blade Retracts from the Matboard (not the Fallout) on the Exterior cut.

    The Exterior Overcut field is marked with a Red Arrow on the Configuration screen and the Map illustration.

    If the Exterior Overcut is cut Too Long, Decrease the Exterior Overcut.

    If the Exterior Overcut is cut Too Short, Increase the Exterior Overcut.

    Crease Exterior Overcut Too Short

    Problem:

    Panel
    panelIconIdatlassian-note
    panelIcon:note:
    bgColor#B3F5FF

    • Exterior Overcut cuts Too Short.

    Resolution:

    Panel
    panelIconIdatlassian-note
    panelIcon:note:
    bgColor#B3F5FF
    Expand
    titleExterior Overcut Definition

    The Exterior Overcut controls where the Blade Retracts from the Matboard (not the Fallout) on the Exterior cut.

    The Exterior Overcut field is marked with a Red Arrow on the Configuration screen and the Map illustration.

    If the Exterior Overcut is cut Too Long, Decrease the Exterior Overcut.

    If the Exterior Overcut is cut Too Short, Increase the Exterior Overcut.