Page Comparison

Note: Not all cartridges are available for all CMC models.

• The Tool Configs on the Configurations Screen displays the global settings for the bevel cartridge tabs. 

• The Opening/Object is cut in the wrong place Horizontally.

• If the Opening is cut too far Left, :

  • Increase the Horizontal Home.

• If the Opening is cut too far Right, :

  • Decrease the Horizontal Home.

• See Horizontal Home for additional information.

The Horizontal Home defines the global Horizontal placement of objects cut with the Blade Cartridges.

If the Opening is cut too far Left, Increase the Horizontal Home.

If the Opening is cut too far Right, Decrease the Horizontal Home.

• The Opening /Object is cut in the wrong place Vertically.

• If the Opening is cut too far Up, :

  • Decrease the Vertical Home.

• If the Opening is cut too far Down, :

  • Increase the Vertical Home.

• See Vertical Home for additional information.

The Vertical Home defines the global Vertical placement of objects cut with the Blade Cartridges.

If the Object is cut too far Up, Decrease the Vertical Home.

If the Object is cut too far Down, Increase the Vertical Home.

• The Opening/Object is cut at the Wrong Depth when a SKU has been selected.

• The Blade Depth is too Deep, :

  • Decrease the Depth Bias.

• The Blade Depth is too Shallow, :

  • Increase the Depth Bias.

• See Depth Bias for additional information.

The Depth Bias is used to calculate the properBlade Depth when the SKUselected for the matboard contains the Matboard Thickness.

The formula is: [(Default Depth) - 10]

For example, if the normal Blade Depth for 4-ply is 11, then 11-10=1, so enter 1 for the Depth Bias.

• The Opening/Object does not Pause for a Blade Change while cutting.

1. Adjust the Plunge Count in the Configuration Screen.

2. Toggle the Plunge Count to On in the Cut Preview.

3. See Plunge Count for additional information.

The Plunge Count controls the number of Blade Plunges for each Blade Cartridge before pausing for a Blade Change.

• The Circle/Oval has a Feather/Bump.

• If the Oval Opening cuts with has a Feather, :

  • Decrease the Oval Rotation.

• If the Oval Opening cuts with has a Bump, :

  • Increase theOval Rotation.

• See Circle/Oval Rotation Utility for additional information.

• See Oval Rotation for additional information.

A Feather in an Oval Opening is a Fringe of material left behind where the cut started and ended.

The Oval Rotation controls for Bumps or Feathers on an Oval Opening.

If the Oval Opening cuts with a Feather, Decrease the Oval Rotation.

A Bump in an Oval Opening is a Lump of material left behind where the cut started and ended.

The Oval Rotation controls for Bumps or Feathers on an Oval Opening.

If the Oval Opening cuts with a Bump, Increase theOval Rotation.