Versions Compared

Old Version 44

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version 45

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Cartridges Involved

This Configuration element involves the following Cartridges.

Info

Note: Not all cartridges are available for all CMC models.

Image Modified

Rotation on Outsides Definition

Expand
titleRotation Definition

The Rotation controls for Swoops and Flares in Non-Oval Objects.

Expand
titleSwoop Definition

A Swoopin a Non-Oval Opening is where the corners Curve Inward toward the opening.

The Rotation controls for Swoops and Flares in Non-Oval Openings.

If the Non-Oval Opening has a Swoop, Increase the Rotation.

Expand
titleFlare Definition

A Flare in aNon-OvalOpening is where the corners Curve Away from the opening.

The Rotation controls for Swoops and Flares in Non-Oval Openings.

If the Non-Oval Opening cuts with a Flare, Decrease the Rotation.

Adjusting the Rotation

Tip

  • To adjust, click

plus

  • Plus/

minus

  • Minus on the desired field about five times.

  • Click OK and do another test cut.

  • Continue making adjustments until the desired outcome is achieved.

Image Modified

Current Bevel Type

Image Modified

Outside has a Swoop

Problem:

Panel
panelIconIdatlassian-note
panelIcon:note:
bgColor#B3F5FF

  • The Non-Oval Outside cuts with a Swoop.

Resolution:

Panel
panelIconIdatlassian-note
panelIcon:note:
bgColor#B3F5FF

  • If the Non-Oval Outside cuts with a Swoop, Increase the Rotation.

Expand
titleSwoop Definition

A Swoopin a Non-Oval Opening is where the corners Curve Inward toward the opening.

The Rotation controls for Swoops and Flares in Non-Oval Openings.

If the Non-Oval Opening has a Swoop, Increase the Rotation.

Image Modified

Outside has a Flare

Problem:

Panel
panelIconIdatlassian-note
panelIcon:note:
bgColor#B3F5FF

  • The Non-Oval Outside cuts with a Flare.

Resolution:

Panel
panelIconIdatlassian-note
panelIcon:note:
bgColor#B3F5FF

  • If the Non-Oval Outside cuts with a Flare, Decrease the Rotation.

Expand
titleFlare Definition

A Flare in aNon-OvalOpening is where the corners Curve Away from the opening.

The Rotation controls for Swoops and Flares in Non-Oval Openings.

If the Non-Oval Opening cuts with a Flare, Decrease the Rotation.

Image Modified

Twisted Corner

Problem:

Panel
panelIconIdatlassian-note
panelIcon:note:
bgColor#B3F5FF

  • A Twisted Corner is when the blade turns before retracting from the matboard, which tears the matboard and twists the corner.

  • This is especially visible from the back of the mat.

Resolution:

Panel
panelIconIdatlassian-note
panelIcon:note:
bgColor#B3F5FF

  • Check to make sure the Rotation hasn't been set to a high number. 

  • Twisted corners can also be a symptom of oil/water in the Air Valve, or an issue with the Head.

  • Check the Air Regulator for excess water.

  • Use the Clean the Foot Block procedure for cleaning the foot block. 

Image Modified