Versions Compared

Old Version 34

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version 35

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Cartridges Involved

This Configuration element involves the following Cartridges.

Info

Note: Not all cartridges are available for all CMC models.

Image Modified

Exterior Overcut on Creases Definition

Adjusting the Exterior Overcut

Tip

  • To adjust, click

plus

  • Plus/

minus

  • Minus on the desired field about five times.

  • Click OK and do another test cut.

  • Continue making adjustments until the desired outcome is achieved.

Expand
titleExterior Overcut Definition

The Exterior Overcut controls where the Blade Retracts from the Matboard (not the Fallout) on the Exterior cut.

The Exterior Overcut field is marked with a Red Arrow on the Configuration screen and the Map illustration.

If the Exterior Overcut is cut

too

Too Long, Decrease the Exterior Overcut.

If the Exterior Overcut is cut

too

Too Short, Increase the Exterior Overcut.

Image Modified

Current Crease Bevel Type

Tip

  • Crease

Image Modified

Crease Exterior Overcut Too Long

Problem:

Panel
panelIconIdatlassian-note
panelIcon:note:
bgColor#B3F5FF

  • The Exterior Overcut is

applied

  • cut Too Long.

Resolution:

Panel
panelIconIdatlassian-note
panelIcon:note:
bgColor#B3F5FF

  • If the Exterior Overcut is cut

too
Expand
titleExterior Overcut Definition

The Exterior Overcut controls where the Blade Retracts from the Matboard (not the Fallout) on the Exterior cut.

The Exterior Overcut field is marked with a Red Arrow on the Configuration screen and the Map illustration.

If the Exterior Overcut is cut

too

Too Long, Decrease the Exterior Overcut.

If the Exterior Overcut is cut

too

Too Short, Increase the Exterior Overcut.

Image Modified

Crease Exterior Overcut Too Short

Problem:

Panel
panelIconIdatlassian-note
panelIcon:note:
bgColor#B3F5FF

  • The Exterior Overcut is

applied

  • cut Too Short.

Resolution:

Panel
panelIconIdatlassian-note
panelIcon:note:
bgColor#B3F5FF

  • If the Exterior Overcut is cut

too
Expand
titleExterior Overcut Definition

The Exterior Overcut controls where the Blade Retracts from the Matboard (not the Fallout) on the Exterior cut.

The Exterior Overcut field is marked with a Red Arrow on the Configuration screen and the Map illustration.

If the Exterior Overcut is cut

too

Too Long, Decrease the Exterior Overcut.

If the Exterior Overcut is cut

too

Too Short, Increase the Exterior Overcut.

Image Modified