Page Comparison

• Move the gantry to the right edge of the CMC.

• Point the head so that the foot block faces toward the CMC and the wheels are close to the bottom of the gantry

• Line up the wheels on the head to the center channels of the gantry arm and ease the head onto the gantry.

• Roll the head up the gantry until it lines up to the head grabber arm on the right side of the gantry.

NOTE: If you are installing the head and having difficulty getting the head wheels onto the gantry, see the Head Wheel Adjustment further down in this document.

• Locate the Head Assembly Power Cable Strain Relief and the two 1/4” screws.

• Slide the tines of the Head Assembly Power Cable Strain Relief around the base sides of the Head Power Plug connection.

• Line up the holes of the Head Assembly Power Cable Strain Relief to the holes on the head grabber arm.

• Holding the head in position so that the head lines up neatly to the Head Assembly Power Cable Strain Relief on the head grabber arm, screw in the two 1/4” screws, making sure they go into the Head Assembly Power Cable Strain Relief and the head grabber arm and then into the head. Tighten firmly.

• If removed, replace the Head Stop Plate to the bottom of the gantry under the belt tensioner after the head is slid onto the gantry.

• Note that the notched side is placed toward the gantry.

• Connect the air to the head by twisting the two air fittings together, matching colors.

• Connect the head power plug (square connection) to the head grabber arm.

• Locate the M12 cable that is attached to the grabber arm.

• Plug the other end of the M12 cable into the M12 port at the top of the head, twisting the thumbscrew to secure it.

• Reinstall the gantry cover using the two screws we removed earlier.

• Make sure that the M12 cable lies within the gantry channel so that it is not pinched in the gantry cover.

• Lift the head up so that the foot block does not strike the side of the board and move the gantry to the left.

• Turn on the air. Turn on the ECU.

• The head is installed.

IMPORTANT: PROCEED TO THE HEAD WHEEL ADJUSTMENT INSTRUCTIONS BELOW.

WARNING: To avoid damage to the head, do not loosen the head wheel screws without first aligning the head to the middle of the board.

• Go to the cut preview screen. Click the power button to align the head.

• Align the head.

• Locate the head wheel adjustment Allen screws on the left side of the head under the head face plate.

• They are next to the head wheels and are marked with red dots.

• Do not touch the Allen screws on the wheels themselves.

• Loosen each head wheel adjustment Allen screw only until the wheels are loose; about two full turns.

• The wheels are spring-loaded and will pop into place.

NOTE: If you are having difficulty getting the head wheels onto the gantry during head installation, loosen the head wheel adjustment screws, roll the head onto the gantry, then continue with the following instructions.

• Grasp the head with both hands and gently rock it back and forth to ensure that the wheels are lined up to the gantry grooves.

• Holding the head up so that it is level with the board, retighten the head wheel adjustment Allen screws consecutively; tighten the top screw half a turn, then the bottom screw half a turn, back to the top and continue until they are both tight.

• Check each of the head wheels to make sure there is no movement.

• There are the two visible wheels on the left side of the head behind the head face plate, and two wheels on the backside of the gantry, which can be felt by hand.

• They should sit firmly into the gantry groove and be difficult to turn.

• If not, repeat these steps of loosening the wheels, gently rocking the head back and forth, then retightening the wheels.

• The head wheels have now been adjusted.

Call Customer Support if you have any questions at 425/551-4300 or 888/855-3335.