Versions Compared

Old Version 32

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version 33

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Cartridges Involved

This Configuration element involves the following Cartridges.

Info

Note: Not all cartridges are available for all CMC models.

Exterior Overcut on Creases Definition

Adjusting the Exterior Overcut

Tip

  • To adjust, click plus/minus on the desired field about five times.

  • Click OK and do another test cut.

  • Continue making adjustments until the desired outcome is achieved.

Expand
titleExterior Overcut Definition

The Exterior Overcut controls  controls where the blade retracts from the matboard on exterior cutsthe Blade Retracts from the Matboard (not the Fallout) on the Exterior cut.

The Exterior Overcut field is marked with a Red Arrow on the Configuration screen and the Map illustration.

If the Exterior Overcut is cut too Long, Decrease the Exterior Overcut.

If the Exterior Overcut is cut too Short, Increase the Exterior Overcut.

Current Crease Bevel Type

Tip

  • Crease

Crease Exterior Overcut Too Long

Problem:

  • The Exterior Overcut is applied Too Long.

Resolution:

Expand
titleExterior Overcut Definition

The Exterior Overcut controls where the blade retracts from the matboard on exterior cuts controls where the Blade Retracts from the Matboard (not the Fallout) on the Exterior cut.

The Exterior Overcut field is marked with a Red Arrow on the Configuration screen and the Map illustration.

If the Exterior Overcut is cut too Long, Decrease the Exterior Overcut.

If the Exterior Overcut is cut too Short, Increase the Exterior Overcut.

Crease Exterior Overcut Too Short

Problem:

  • The Exterior Overcut is applied Too Short.

Resolution:

Expand
titleExterior Overcut Definition

The Exterior Overcut controls where the blade retracts from the matboard on exterior cuts controls where the Blade Retracts from the Matboard (not the Fallout) on the Exterior cut.

The Exterior Overcut field is marked with a Red Arrow on the Configuration screen and the Map illustration.

If the Exterior Overcut is cut too Long, Decrease the Exterior Overcut.

If the Exterior Overcut is cut too Short, Increase the Exterior Overcut.