Versions Compared

Version Old Version 13 New Version 14
Changes made by

dani.simmonds

dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Cut the Outside as a Shared Edge

  • Select Shared Edge from the Outside Cut Options dropdown control to cut the shared edges of the outside cuts on the CMC Z1 and Z (9000z).   

Expand
titleShared Edge Definition

Select The Shared Edge from the Outside Cut Options dropdown control to function will cut the shared edges Shared Edges of the outside cuts Tiled Outside Cuts on the CMC Z1 and Z (9000z) as one stroke between the designs, instead of cutting the outside of each mat individually.   

  • When Tiling, make sure that the Spacing under the Setup Tab is set to zero Zero (0) so that each design shares the outside Outside lines with the next design, so it will only cut the single line between them. 

  • If you have Remnant Trimming on, it will also cut off the scrap edge.

Expand
titleRemnant Trimming Definition

Remnant Trimming feature trims off the remaining portion of the mat Horizontally or Vertically after cutting the design to make storing the leftovers easier.

Advanced Outside Options

Info

  • The shared outside Shared Outside edges of the tiled Tiled design will cut in one stroke. 

  • If you have Remnant Trimming on, it will also cut off the scrap edge.

Expand
titleRemnant Trimming Definition

Remnant Trimming feature trims off the remaining portion of the mat Horizontally or Vertically after cutting the design to make storing the leftovers easier.

Defaults: Set the Default for Cutting the Outside 

Expand
titleDefault Setting for Cutting the Outside

The default setting for Cutting the Outside can be set in the Admin > Editor section.

...