Versions Compared

Old Version 31

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version 32

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Cartridges Involved

This Configuration element involves the following Cartridges.

Info

Note: Not all cartridges are available for all CMC models.

Exterior Overcut on Creases Definition

Expand
titleExterior Overcut Definition

The Exterior Overcut controls where the cartridge retracts from the matboard on exterior cuts.

Adjusting the Exterior Overcut

Tip

  • To adjust, click plus/minus on the desired field about five times.

  • Click OK and do another test cut.

  • Continue making adjustments until the desired outcome is achieved.

Expand
titleExterior Overcut Definition

The Exterior Overcut controls where the blade retracts from the matboard on exterior cuts.

Current Crease Bevel Type

Tip

  • Crease

Crease Exterior Overcut Too Long

Problem:

  • The Exterior Overcut is applied too longToo Long.

Resolution:

Expand
titleExterior Overcut Definition

The The Exterior Overcut controls where the cartridge blade retracts from the matboard on exterior cuts.

Resolution:

Decrease the Exterior Overcut

.

Crease Exterior Overcut Too Short

Problem:

  • The Exterior Overcut is applied too shortToo Short.

Resolution:

Expand
titleExterior Overcut Definition

The The Exterior Overcut controls where the cartridge blade retracts from the matboard on exterior cuts.

Resolution:

Increase the Exterior Overcut

.