Versions Compared

Old Version 38

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version 39

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Cartridges Involved

This Configuration element involves the following Cartridges.

Info

Note: Not all cartridges are available for all CMC models.

Rotation on Outsides Definition

Expand
titleRotation Definition

The Rotation controls for Swoops and Flares in non-oval objects.

If the Non-Oval Outside cuts with a Swoop, Increase the Rotation.

If the Non-Oval Outside cuts with a Flare, Decrease the Rotation.

Expand
titleSwoop Definition

A Swoop in a Non-Oval Outside is where the corners curve inward toward the opening.

If the Non-Oval Outside cuts with a Swoop, Increase the Rotation.

Expand
titleFlare Definition

A Flarein a Non-Oval Outside is where the corners curve away from the opening.

If the Non-Oval Outside cuts with a Flare, Decrease the Rotation.

Adjusting the Rotation

Tip

  • To adjust, click plus/minus on the desired field about five times.

  • Click OK and do another test cut.

  • Continue making adjustments until the desired outcome is achieved.

Current Bevel Type

Outside has a Swoop

Problem:

  • A Swoopin a The Non-Oval Outside is where the corners curve inward toward the openingcuts with a Swoop.

Resolution:

  • If the Non-Oval Outside cuts with a Swoop, Increase the Rotation.

Outside has a Flare

Problem:

  • A Flare in a The Non-Oval Outside is where the corners curve away from the openingcuts with a Flare.

Resolution:

  • If the Non-Oval Outside cuts with a Flare, Decrease the Rotation.

Twisted Corner

Problem:

  • A Twisted Corner is when the blade turns before retracting from the matboard, which tears the matboard and twists the corner.

  • This is especially visible from the back of the mat.

Resolution:

  • Check to make sure the Rotation hasn't been set to a high number. 

  • Twisted corners can also be a symptom of oil/water in the Air Valve, or an issue with the Head.

  • Check the Air Regulator for excess water.

  • Use the Clean the Foot Block procedure for cleaning the foot block.