Versions Compared

Old Version 11

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version 12

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Aligning the Head on the CMC 8000

  • Rotate the foot block into the 12 O’Clock position. 

  • Holding it about an inch above the bottom rail, slide the gantry and the head assembly to the left edge of the CMC until it stops. 

  • It will stop against the Magnetic Stop.

  • Then slide the head down until the foot block rests against the head alignment stop.

  • Click the Align the Head button or click the Cut button to finish the Align the Head sequence.

  • Click Continue on the Align the Head screen.

Image Modified

  • Head will align to the home position.

  • If you clicked the Align the Head button, the CMC is now aligned and ready to cut.

  • If you clicked the Cut button, the CMC will now begin to cut the mat.

...