Versions Compared

Old Version 28

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version 29

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Cartridges Involved

This Configuration element involves the following Cartridges.

Info

Note: Not all cartridges are available for all CMC models.

Exterior Overcut on Creases Definition

Expand
titleExterior Overcut Definition

The Exterior Overcut controls where the cartridge retracts from the matboard on exterior cuts.

Tip

  • To adjust, click plus/minus on the desired field about five times.

  • Click OK and do another test cut.

  • Continue making adjustments until the desired outcome is achieved.

The Exterior Overcut is displayed on the Configuration Map and on the associated field as a red arrow.

Current Crease Bevel Type

Tip

  • Crease

Image Removed
Info

  • To adjust, click plus/minus on the field about five times.

  • Click OK and do another test cut.

    • Continue making adjustments until the desired outcome is achieved

    • .

    Crease Exterior Overcut Too Long

    Problem:

    • The Exterior Overcut is applied too long.

    Expand
    titleExterior Overcut Definition

    The Exterior Overcut controls where the cartridge retracts from the matboard on exterior cuts.

    Resolution:

    • Decrease the Exterior Overcut.

    Info

  • To adjust, click plus/minus on the field about five times.

  • Click OK and do another test cut.

    • Continue making adjustments until the desired outcome is achieved

    • .

    Crease Exterior Overcut Too Short

    Problem:

    • The Exterior Overcut is applied too short.

    Expand
    titleExterior Overcut Definition

    The Exterior Overcut controls where the cartridge retracts from the matboard on exterior cuts.

    Resolution:

    • Increase the Exterior Overcut.

    Info