Content Comparison

Note: Not all cartridges are available for all CMC models.

• The Horizontal Home defines the global horizontal placement of objects cut with the blade cartridges when not cutting the outside of the mat. 

• This is measured from the inside of the bevel to the edge of the mat.

• This is viewed as it cut on the machine, i.e., from the back if cutting from the back, or from the front if cutting from the front.

The Horizontal Home controls where the opening is cut Horizontally.

• To adjust, click plus/minus on the field about five times.

• Click OK and do another test cut.

• Continue making adjustments until the desired outcome is achieved.

The Horizontal Home controls where the opening is cut Horizontally.

• To adjust, click plus/minus on the field about five times.

• Click OK and do another test cut.

• Continue making adjustments until the desired outcome is achieved.

• To adjust the Horizontal Adjustment placement of the non-blade Tools (Deboss, PenorVinyl), see Horizontal Adjustment.