Versions Compared

Old Version 26

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version 27

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Cartridges Involved

This Configuration element involves the following Cartridges.

Info

Note: Not all cartridges are available for all CMC models.

Exterior Overcut on Creases Definition

Infoexpand
titleExterior Overcut Definition

The Exterior Overcut controls where the cartridge retracts from the matboard on exterior

cuts.The Exterior

cuts

into the matboard, not the fallout.The Exterior Overcut field is marked with a Red Arrow

.

Current Crease Bevel Type

Tip

  • Crease

Info

  • The Exterior Overcut is displayed on the Configuration Map and on the associated field as a red arrow.

Crease Exterior Overcut Too Long

Problem:

  • The Exterior Overcut is applied too long.

Resolution:

  • Decrease the Exterior Overcut.

Image Removed

Info

  • To adjust, click plus/minus on the field about five times.

  • Click OK and do another test cut.

  • Continue making adjustments until the desired outcome is achieved.

Crease Exterior Overcut Too Short

Problem:

  • The Exterior Overcut is applied too short.

Resolution:

  • Increase the Exterior Overcut.

Image Removed

Info

  • To adjust, click plus/minus on the field about five times.

  • Click OK and do another test cut.

  • Continue making adjustments until the desired outcome is achieved.