Versions Compared

Old Version 15

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version 16

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Cartridges Involved

This Configuration element involves the following Cartridges.

Info

Note: Not all cartridges are available for all CMC models.

Tool Configs Section

Info

The Tool Configs on the Configurations Screen displays the global settings for the bevel cartridge tabs. 

Horizontal 

Problem:

  • The opening/object is cut in the wrong place Horizontally.

Expand
titleHorizontal Home Definition

The Horizontal Home controls where the opening is cut Horizontally.

Resolution:

  • If too far left, increase the Horizontal Home.

  • If too far right, decrease the Horizontal Home.

  • See Horizontal Home for additional information.

Info

Vertical 

Problem:

  • The opening/object is cut in the wrong place Vertically.

Expand
titleVertical Home Definition

The Vertical Home controls specifically where the opening is cut Vertically.

Resolution:

  • If too far down, increase the Vertical Home.

  • If too far up, decrease the Vertical Home.

  • See Vertical Home for additional information.

 

Info

Depth Bias 

Problem:

  • The opening/object is cut at the wrong depth when a SKU has been selected.

Expand
titleDepth Bias Definition

The Depth Bias calculates the proper Blade Depth when a SKU is selected for the matboard.

Resolution:

  • Cut too shallow, increase the Depth Bias.

  • Cut too deep, decrease the Depth Bias.

  • See Depth Bias for additional information.

Plunge Count 

Problem:

  • The opening/object does not pause for a blade change while cutting.

Expand
titlePlunge Count Definition

The Plunge Count controls the number of plunges for the individual blade cartridges to pause for a Blade Change.

Resolution:

  • If cuts too long before pausing, decrease the Plunge Count.

  • If cuts too short before pausing, increase the Plunge Count.

  • See Plunge Count for additional information.

Circle/Oval Rotation Button

Problem:

  • The Circle/Oval cuts with a Feather/Bump.

Expand
titleFeather Definition

The oval cuts with a Feather of material left into the opening.

The Circle/Oval Rotation controls for Bumps or Feathers on an Oval Opening.

Expand
titleBump Definition

The oval cuts with a Bump of material left into the opening.

The Circle/Oval Rotation controls for Bumps or Featherson an Oval Opening.

Resolution:

  • If cuts with a Feather, decrease the Oval Rotation.

  • If it cuts with a Bump, increase the Oval Rotation.

  • See Circle/Oval Rotation Utility for additional information.

  • See Oval Rotation for additional information.