Versions Compared

Old Version 18

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version 19

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Cartridges Involved

This Configuration element involves the following Cartridges.

Info

Note: Not all cartridges are available for all CMC models.

...

Select the Bevel Type for the Exterior Overcut to be Edited:

Exterior Overcut on Openings

Problem:

  • The Exterior Overcut on Openings is cut too long/too short.

Resolution:

Edit the 

  • If the exterior overcut is too long, decrease the Exterior Overcut.

  • If the exterior overcut is too short, increase the Exterior Overcut.

  • See Exterior Overcut on Openings for additional information.

Tip

  • Normal Bevel

  • Reverse Bevel

  • Normal Bevel-Front of Mat

  • Reverse Bevel-Front of Mat

Exterior Overcut on Drops 

Problem:

  • The Exterior Overcut on Drops is cut too long/too short.

Resolution:

Adjust the 

  • If the exterior overcut is too long, decrease the Exterior Overcut.

  • If the exterior overcut is too short, increase the Exterior Overcut.

  • See Exterior Overcut on Drops for additional information.

Tip

  • Normal Drop

  • Reverse Drop

  • Normal Drop-Front of Mat

  • Reverse Drop-Front of Mat

Exterior Overcut on the Outside

Problem:

  • The Exterior Overcut for Outsides is cut too long/too short.

Resolution:

Adjust the 

  • If the exterior overcut is too long, decrease the Exterior Overcut.

  • If the exterior overcut is too short, increase the Exterior Overcut.

  • See Exterior Overcut on the Outside for additional information.

Tip

  • Outside

  • Outside-Front of Mat

Exterior Overcut on V-Grooves 

Problem:

  • The Exterior Overcut for V-Grooves is cut too long/too short.

Resolution:

  • Adjust the If the exterior overcut is too long, decrease the Exterior Overcut.

  • If the exterior overcut is too short, increase the Exterior Overcut.

  • See Exterior Overcut on V-Grooves for additional information.

Tip

  • V-Grooves

Exterior Overcut on Creases

Problem:

The Exterior Overcut on Creases is applied too long/too short.

Resolution:

  • Adjust the If the exterior overcut is too long, decrease the Exterior Overcut.

  • If the exterior overcut is too short, increase the Exterior Overcut.

  • See Exterior Overcut on Creases for additional information.

Tip

  • Crease