Versions Compared

Old Version 14

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version 15

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Cartridges Involved

This Configuration element involves the following Cartridges.

Info

Note: Not all cartridges are available for all CMC models.

Tool Configs Section

Info

The Tool Configs on the Configurations Screen displays the global settings for the bevel cartridge tabs. 

Horizontal 

Problem:

  • The opening/object is cut in the wrong place Horizontally.

Resolution:

Adjust

  • If too far left, increase the Horizontal Home.

  • If too far right, decrease the Horizontal Home.

Select this topic to see information on the Horizontal Home which defines the global horizontal placement of objects cut with the blade cartridges. 

Info

Vertical 

Problem:

  • The opening/object is cut in the wrong place Vertically.

Resolution:

  • Adjust If too far down, increase the Vertical Home.

  • If too far up, decrease the Vertical Home.

Select this topic to see information on the Vertical Home which defines the global vertical placement of objects cut with the blade cartridges. 

 

Info

Depth Bias 

Problem:

  • The opening/object is cut at the wrong depth when a SKU has been selected.

Resolution:

  • Adjust Cut too shallow, increase the Depth Bias.

  • Cut too deep, decrease the Depth Bias.

Select this topic to see information on the 
which is used to calculate the proper blade depth when a SKU has been selected

  • for additional information.

Plunge Count 

Problem:

  • The opening/object does not pause for a blade change while cutting.

Resolution:

Adjust

  • If cuts too long before pausing, decrease the Plunge Count.

  • If cuts too short before pausing, increase the Plunge Count.

Select this topic to see information on the 
, which is the number of plunges for this particular blade cartridge before pausing for a blade change

  • for additional information.

Circle/Oval Rotation Button

Problem:

  • The Circle/Oval cuts with a Feather/Bump.

Resolution:

  • Use the If cuts with a Feather, decrease the Oval Rotation.

  • If it cuts with a Bump, increase the Oval Rotation.

  • See Circle/Oval Rotation Utility to correct for Feathers/Bumps.

Select this topic to see information on the Circle/Oval Rotation Utility to adjust the oval rotation for different size ovals

  •  for additional information.

  • See Oval Rotation for additional information.