Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Location Tab

Info

The Location tab allows the user to specify the desired position on the board to cut the current design. This is helpful when calibrating, avoiding flaws in the matboard, reusing scraps, etc.

X and Y Origin

Use the X Origin (Horizontal) and Y Origin (Vertical) fields to specify the location to cut the current mat.

  • Click on the design to select it.

  • Enter a new or Y Origin value and tab out of the field.

  • It will move the lower left corner of the current design to the new X/Y position on the Cut Preview Screen.

  • Previous cuts are displayed in grey to help the user position the current design on the screen.

  • To clear the previous cuts from the screen, see Clear Cut History.

...

Defaults: Set the Default for the Enable Auto Clamp Offset

The default setting for the Enable Auto Clamp Offset for the CMC Z1 and Z (9000z) can be set in the Admin > Cutting section.

...