Page Comparison

The Outside Rotation controls for Swoopsor Flareson the outside cut on non-oval V-Grooves.

• The first cut is the interior V-Groove line and cut into the V-Groove fallout and not the matboard, and is cut in a clockwise direction. This uses the Inside Rotation.

• The second cut is the exterior V-Groove line and cut into the matboard and not on the V-Groove fallout, and is cut in a counter-clockwise direction. This uses the Outside Rotation.

• When making adjustments, click the plus or minus button at the end of the desired field about four times.

• In Rotation, eight points equals one degree of rotation. Users usually make adjustments four points at a time.

• Click OK and do another test cut.

• Check the results of the cut and continue making adjustments until the desired outcome is achieved.

• When making adjustments, click the plus or minus button at the end of the desired field about four times.

• In Rotation, eight points equals one degree of rotation. Users usually make adjustments four points at a time.

• Click OK and do another test cut.

• Check the results of the cut and continue making adjustments until the desired outcome is achieved.