Versions Compared

Version Old Version 12 New Version 13
Changes made by

dani.simmonds

dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Cartridges Involved

This Configuration element involves the following Cartridges.

Info

Note: Not all cartridges are available for all CMC models.

Vertical Adjustment for Non-Blade Cartridges Definition

Info

The Vertical Adjustment controls where the Tool (Deboss, Penor Vinyl) is applied Vertically.

Select the Tool and Type

Tool Line Too Far Up

Problem:

  • The tool line is applied too far up vertically.

Resolution:

Info

  • When making adjustments, click the plus or minus button at the end of the desired field about five times.

  • Click OK and do another test cut.

  • Check the results of the cut and continue making adjustments until the desired outcome is achieved.

Tool Line Too Far Down

Problem:

  • The tool line is applied too far down Vertically.

Resolution:

Info

  • When making adjustments, click the plus or minus button at the end of the desired field about five times.

  • Click OK and do another test cut.

  • Check the results of the cut and continue making adjustments until the desired outcome is achieved.

Opening Cuts in the Wrong Place Vertically when not cutting the Outside

Problem:

  • The opening cuts in the wrong place Vertically.

Resolution: