Versions Compared

Old Version 30

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version 31

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

Rotation on V-Grooves Definition

The Outside Rotation controls for Swoopsor Flareson the outside cut on non-oval V-Grooves.

Because this is a V-Groove, you will be using either the Outside Rotation or the Inside Rotation, based on which V-Groove line you are editing

.

  • The first cut is the interior V-Groove line and cut into the V-Groove fallout and not the matboard, and is cut in a clockwise direction. This uses the Inside Rotation.

  • The second cut is the exterior V-Groove line and cut into the matboard and not on the V-Groove fallout, and is cut in a counter-clockwise direction. This uses the Outside Rotation.

V-Groove Outside has a Swoop

Problem:

  • The Outside cut of the non-oval V-Groove has Swoops.

Resolution:

  • Decrease the Outside Rotation. Adjust until the object cuts without a Swoop.

  • When making adjustments, click the plus or minus button at the end of the desired field about four times.

  • In Rotation, eight points equals one degree of rotation. Users usually make adjustments four points at a time.

  • Click OK and do another test cut.

  • Check the results of the cut and continue making adjustments until the desired outcome is achieved.

V-Groove Outside has a Flare

Problem:

  • The Outside cut of the non-oval V-Groove has Flare.

Resolution:

  • Increase the Outside Rotation value. Adjust until the object cuts without a Swoop/Flare.

  • When making adjustments, click the plus or minus button at the end of the desired field about four times.

  • In Rotation, eight points equals one degree of rotation. Users usually make adjustments four points at a time.

  • Click OK and do another test cut.

  • Check the results of the cut and continue making adjustments until the desired outcome is achieved.

Image RemovedImage Modified

See Also: V-Groove Inside Rotation

Problem:

  • The Inside Cut of the non-oval V-Groove cuts with a Swoop/Flare.

Resolution:

  • Edit the Inside Rotation (V-Groove).

    • The Inside Rotation controls for Swoopsand Flaresfor inside cuts on non-oval V-Grooves.
    Image Modified

    See Also: Troubleshooting Utility for Non-Oval V-Grooves

    Problem:

    • The Non-Oval V-Groove cuts with a Swoop/Flare.

    Resolution: