Page Comparison

Versions Compared

Key

This line was added.
This line was removed.
Formatting was changed.

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

...

V-Groove Outside has a Swoop

Problem:

The Outside cut of the non-oval V-Groove has Swoops.

Resolution:

Decrease the Outside Rotation. Adjust until the object cuts without a Swoop.

When making adjustments, click the plus or minus button at the end of the desired field about four times.
In Rotation, eight points equals one degree of rotation. Users usually make adjustments four points at a time.
Click OK and do another test cut.
Check the results of the cut and continue making adjustments until the desired outcome is achieved.

V-Groove Outside has a Flare

Problem:

The Outside cut of the non-oval V-Groove cuts with ahas Flare.

Resolution:

Increase the Outside Rotation value. Adjust until the object cuts without a Swoop/Flare.

When making adjustments, click the plus or minus button at the end of the desired field about four times.
In Rotation, eight points equals one degree of rotation. Users usually make adjustments four points at a time.
Click OK and do another test cut.
Check the results of the cut and continue making adjustments until the desired outcome is achieved.

See Also: V-Groove Inside Rotation

Problem:

The Inside Cut of thenon-oval V-Groove cuts with a Swoop/Flare.

Resolution:

Edit the Inside Rotation (V-Groove).
The Inside Rotation controls for Swoopsand Flaresfor inside cuts on non-oval V-Grooves.

See Also: Troubleshooting Utility for Non-Oval V-Grooves

Problem:

The Non-Oval V-Groove cuts with a BumpSwoop/FeatherFlare.

Resolution:

Use the Troubleshooting Configurations to fine-tune for BumpsSwoop/FeathersFlare in a Non-Oval V-Groove.