Versions Compared

Old Version 16

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version 17

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

Exterior Overcut

Definition

on Creases Definition

  • The Exterior Overcut controls where the cartridge retracts from the matboard on exterior cuts.

  • The Exterior cuts cut into the matboard, not the fallout.

  • The Exterior Overcut field is marked with a Red Arrow.

...

Crease Exterior Overcut Too Long

Problem:

  • The Exterior Overcut is applied too long.

Resolution:

  • Decrease the Exterior Overcut. Adjust until the corners meet up properly.

When making adjustments, click the plus or minus button at the end of the desired field about five times.

Click OK and do another test cut.

Check the results of the cut and continue making adjustments until the desired outcome is achieved.

Crease Exterior Overcut Too Short

Problem:

  • The Exterior Overcut is applied too short.

Resolution:

  • Increase the Exterior Overcut. Adjust until the corners meet up properly.

When making adjustments, click the plus or minus button at the end of the desired field about five times.

Click OK and do another test cut.

Check the results of the cut and continue making adjustments until the desired outcome is achieved.