Page Comparison

• The Outside Rotation controls for Swoopsand Flaresfor outside cuts on non-oval V-Grooves.

• The Inside Rotation controls for Swoopsand Flaresfor inside cuts on non-oval V-Grooves.

The Rotation field controls how much the foot block will rotate before cutting. Because this is a V-Groove, you will be using either the Outside Rotation or the Inside Rotation, based on which V-Groove line you are editing.

• The first cut is the interior V-Groove line.

• The second cut is the exterior V-Groove line.

Adjust the Outside Rotation if you are getting Swoopsor Flaresin the outside corners on a non-oval opening.

• Increase the Outside Rotationif the object has a Swoop on the outside cut of the V-Groove.

• Decrease the Outside Rotationif the object has a Flare on the outside cut of the V-Groove.

Problem:

• The Outside V-Groove cuts with a Swoop.

Resolution:

• Decrease the Outside Rotation.

• The Outside Rotation controls for Swoopsand Flaresfor outside cuts on non-oval V-Grooves.

• When making adjustments, click the minus button (-) at the end of the desired field about five or six times.

• Click OK and do a test cut.

• Check the results of the cut and continue making adjustments until the desired outcome is achieved.

• The object will now cut correctly.

Problem:

• The Outside V-Groove cuts with a Flare.

Resolution:

• Increase the Outside Rotation value. 

• The Outside Rotation controls for Swoopsand Flaresfor outside cuts on non-oval V-Grooves.

• When making adjustments, click the plus button (+) at the end of the desired field about five or six times.

• Click OK and do a test cut.

• Check the results of the cut and continue making adjustments until the desired outcome is achieved.

• The object will now cut correctly.

Problem:

• The Inside Cut of the V-Groove cuts with a Swoop/Flare.

Resolution:

• Edit the Inside Rotation (V-Groove).

• The Inside Rotation controls for Swoopsand Flaresfor inside cuts on non-oval V-Grooves.