Page Comparison

Versions Compared

Key

This line was added.
This line was removed.
Formatting was changed.

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

...

Problem: Crease Exterior Overcut Too Long

Problem:

The Exterior Overcut is applied too long.
This is viewed from the front of the mat.

Resolution:

Decrease the Exterior Overcut.
When making adjustments, click the minus button (-) at the end of the desired field about five or six times.
Click OK and do a test cut.
Check the results of the cut and continue making adjustments until the desired outcome is achieved.

Image Removed

The corners will now meet up properly.

Image Modified

Image Added

Problem: Crease Exterior Overcut Too Short

Problem:

The Exterior Overcut is applied too short.
This is viewed from the front of the mat.

Resolution:

Increase the Exterior Overcut.
When making adjustments, click the plus button (+) at the end of the desired field about five or six times.
Click OK and do a test cut.
Check the results of the cut and continue making adjustments until the desired outcome is achieved.

Image Removed

The corners will now meet up properly.

Image Added