Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

...

Red Arrow on the Configurations Screen

  • The Exterior Overcut is displayed on the Configuration Map and on the associated field as a red arrow.

Problem: Crease Exterior Overcut Too Long

Problem:

  • The Exterior Overcut is applied too long.

  • This is viewed from the front of the mat.

  • The Exterior Overcut is applied too long.

Image RemovedImage Added

Resolution:

  • Decrease the Exterior Overcut.

  • When making adjustments, click the minus button (-) at the end of the desired field about five or six times.

  • Click OK and do a test cut.

  • Check the results of the cut and continue making adjustments until the desired outcome is achieved.

  • The corners will now meet up properly.

Problem: Crease Exterior Overcut Too Short

Problem:

  • The Exterior Overcut is applied too short.

  • This is viewed from the front of the mat.

  • The Exterior Overcut is applied too short.

Image RemovedImage Added

Resolution:

  • Increase the Exterior Overcut.

  • When making adjustments, click the plus button (+) at the end of the desired field about five or six times.

  • Click OK and do a test cut.

  • Check the results of the cut and continue making adjustments until the desired outcome is achieved.

  • The corners will now meet up properly.