Page Comparison

• Select As Designed from the Outside Cut Options dropdown control to cut the outside as originally designed on the CMC Z1 and Z (9000z)/

• This can be helpful when coming from Traceor Nesting where you have already determined how you want the outside to be cut.

• If you have Remnant Trimming on, it will also cut off the scrap edge.

• The same Outside Cut Options are available on the Advanced Outside Options screen from the Cut Mode dropdown control.

• Click the Set Advanced Options button on theCut Preview screen.

• On the Advanced Outside Options screen, set the Cut Mode to As Designed. The Cut Mode matches the selections from the Outside Cut Options as described above.

• This can be helpful when coming from Trace or Nesting where you had already selected how you want the outside(s) to be cut.  

• If you have Remnant Trimming on, it will also cut off the scrap edge.

The default setting for Cutting the Outside can be set in the Admin > Editor section.

The default setting for 90 Degree Outside can be set in the Admin > Cutting section.

The default setting for the Advanced Options can be set in the Admin > Cutting section.