Page Comparison

• Select Full from the Outside Cut Options dropdown control to cut the complete outside edge of the design on the CMC Z1 and Z (9000z).

• When tiling mats, it will cut out the complete outside edge of each design.

• If you have Remnant Trimming on, it will also cut off the scrap edge.

• The same Outside Cut Options are available on the Advanced Outside Options screen from the Cut Mode dropdown control.

• Click the Set Advanced Options button on the Cut Preview screen.

• On the Advanced Outside Options screen, set the Cut Mode to Full. The Cut Mode matches the selections from the Outside Cut Options as described above.

• The full outside edge of the design or tiled designs will be cut. 

• If you have Remnant Trimming on, it will also cut off the scrap edge.

The default setting for Cutting the Outside can be set in the Admin > Editor section.

The default setting for 90 Degree Outside can be set in the Admin > Cutting section.

The default setting for the Advanced Options can be set in the Admin > Cutting section.