Page Comparison

• Loosen the three screws on the back of the backing board stabilizers.

• Both the left stabilizer and the right one have a set of three screws.

• Take care to only loosen them, not remove them.

• Remove the current backing board.

• It is held in place with double-sided tape.

If the AirGlide has not yet been squared, refer to the AirGlide Operations Manual for instructions on how to square it.

• Pre-fit the backing board into the AirGlide.

• The board should slip in between the Horizontal Rail and the Backing Board Stabilizer.

• Make sure that all edges of the backing board line up to the Gantry and the Horizontal Rail.

• Gently pull the backing board away from the AirGlide frame.

• Starting at the bottom, remove the paper covering the adhesive from the double-sided tape.

• Once the paper covering has been removed, firmly push the backing board against the length of the gantry to secure the bond of the double-sided tape to hold the backing board in place.