Versions Compared

Old Version 37

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version 38

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

View file
nameAirClampReplacement8500800050002021-12-28.pdf

Air Clamp Removal: CMC 8500, 8000 and 5000

  • When an Air Clamp blows/leaks, it needs to be replaced.

  • Move the Gantry to the right until it moves no further.

  • Determine which Clamp is leaking and remove the appropriate Clamp mounting screws with an Allen wrench.

  • Loosen the 7/64” Allen Screw holding the Air Clamp, and gently lift Vertical/Horizontal Clamp to view small air hose fitting.

  • Lift fitting from its groove and disconnect it by unscrewing the two halves.

  • On later machines, simply pull the two hoses apart.

  • Lay the Vertical/Horizontal Clamp upside down to look at its construction.

  • Loosen the two Allen screws at each end of the rubber tube until you can pull the Air Clamp out.

  • The Air Clamp has been removed.

Air Clamp Replacement

  • Place the metal end of the Air Clamp (side without hose) into the slot closest to the end of clamp bar.

  • Push the metal end firmly into clamp bar and tighten the Allen screw.

  • Each Allen screw should have two washers and should be tightened against the flat side of the metal crimp.

  • Grasp the other side of the Air Clamp and stretch until the other metal ring can be inserted into its slot.

  • Push the metal ring into clamp bar and tighten the Allen screw.

  • Each Allen screw should have two washers and should be tightened against the flat side of the metal crimp.

  • While holding the Vertical/Horizontal Clamp near its mounting position, attach the air fitting and lead the air fitting to its pocket.

  • Slip the fitting into its pocket as the clamp is being turned over into its mounting position.

  • Align the mounting holes and screw the Vertical/Horizontal Clamp back onto the CMC by tightening the two outside screws first, then the inside screws to ensure that the Rail is level.