The Enable Rail Dodge will move the design up and over on the matboard to avoid the clamping area on the CMC 9000 and 8000. Click on the design to select it. Check the Enable Rail Dodge checkbox to use a Rail Dodge on CMC 9000 and 8000. A Rail Dodge is a small piece of matboard or other material used to position the pre-cut matboard up into the cutting area when using borders less than 1.5" and not cutting the outside. Enter the distance to move the design in the X Origin field; the Y Origin field uses the same numerical value. It will move the lower left corner of the design to the new X/Y position and it will display Dodge on the bottom of the screen. Note: The outside cut is shown here merely for visual reference of where the pre-cut matboard will be positioned on the board. This feature can also be used to move the design to avoid flaws in the matboard.
See Also: Fixture for Rail Dodge. |