...
Aligning the Head on the CMC 8000 | |
|---|---|
Rotate the foot block into the 12 O’Clock position. Rotate the foot block with the blade cartridge on top of the head. |  |
Holding it about an inch above the bottom rail, slide the gantry and the head assembly to the left edge of the CMC until it stops. |  |
It will stop against the Magnetic Stop. |  |
Then slide the head down until the foot block rests against the head alignment stop. |  |
Click the Align the Head button or click the Cut button to finish the Align the Head sequence. | |
Click Continue on the Align the Head screen. | |
Head will align to the home position. |  |
If you clicked the Align the Head button, the CMC is now aligned and ready to cut. If you clicked the Cut button, the CMC will now begin to cut the mat. |   |
See Also: Disengage Button | |
|---|---|
Use the Disengage button to cut the power to the motors of the cutting head. | |
Click the Disengage button to disengage power to the motors of the cutting Head on the CMC. User will be prompted to Click OK to release the motors. Grasp the Head and then Click OK. The motors will be disengaged and the Head will drop. When the motors are disengaged, the Head and the Gantry can be moved freely by hand. The head will need to be Aligned again before the next mat is cut. | Click the Reset Motors Head Button to Disengage Power to the Motors |