Cut the Outside Toggle |
|---|
Use the Cut the Outside toggle to select cutting or not cutting the outside of the mat for the CMC Z1, Z (9000z), 9000, and 8000. |
...
Set Advanced Options: Enable Outside Cut | |
|---|---|
Optionally, the outside cut can be turned on or off from the Advanced Outside Options: Enable Outside Cut toggle for the CMC Z1 and Z (9000z). | |
Set the Default for Cutting the Outside | |
|---|---|
The default setting for Cutting the Outside can be set in the Admin > Editor section for the CMC Z1, Z (9000z), 9000 and 8000. | |
Set the Default for 90 Degree Outside Cut | |
|---|---|
The default setting for 90 Outside Cuts can be set in the Admin > Cutting section for the CMC Z1, Z (9000z) and 9000. Note that the CMC 8000 does support cutting with the 90 Degree Cartridge. | |
...
Disable Auto Clamp Offset | |
|---|---|
Disabling the Auto Clamp Offset will cut the design normally without being offset an extra distance into the mat on the CMC Z1 and Z (9000z). | |
Uncheck the Auto Clamp Offset checkbox. The design will no longer be offset on the CMC Z1 and Z (9000z) and will cut the design normally unless values have been entered in the X Origin and Y Origin fields as described above. | |
Set the Default for the Enable Auto Clamp Offset | |
|---|---|
The default setting and offset value for the Enable Auto Clamp Offset for the CMC Z1 and Z (9000z) can be set in the Admin > Cutting section. | |
...
Disable Rail Dodge | |
|---|---|
Disabling the Rail Dodge will now cut the designs normally without being offset up and over on the mat. | |
Uncheck the Rail Dodge checkbox. The design will no longer be offset on the CMC 8000 and 9000 and will cut the design normally unless values have been entered in the X Origin and Y Origin fields as described above | |
Set the Default for the Rail Dodge | |
|---|---|
The default setting and offset value for the Rail Dodge can be set in the Admin > Cutting section. | |
Edit Menu: Cut Outside | |
|---|---|
Optionally, you can use the Edit menu to cut the outside of the design. Click on the design to select it. Click Edit > Cut Outside to cut the outside of the mat. | |