Location Tab | |
|---|---|
The Location tab allows the user to specify the desired position on the board to cut the current design. This is helpful when calibrating, avoiding flaws in the matboard, reusing scraps, etc. | |
...
Matboard Size | |
|---|---|
The size of the matboard is entered on the Setup Tab on the Sheet Size fields. | |
Enter the desired matboard sheet size on the Setup Tab on the Sheet Size field. The software will use the matboard size as the maximum limitation when tiling mats and when moving mats with the Location Tab. | |
Set the Defaults for Tiling | |
|---|---|
The default setting for Tiling can be set in the Admin > Cutting section. | |
...
Disable Auto Clamp Offset | |
|---|---|
Disabling the Auto Clamp Offset will cut the design normally without being offset into the mat on the CMC Z1 and Z (9000z). | |
Uncheck the Enable Auto Clamp Offset checkbox. The design will no longer be offset on the CMC Z1 and Z (9000z) and will cut the design normally unless values have been entered in the X Origin and Y Origin fields as described above. | |
Set the Default for the Enable Auto Clamp Offset | |
|---|---|
The default setting for the Enable Auto Clamp Offset for the CMC Z1 and Z (9000z) can be set in the Admin > Cutting section. | |
...
Disable Rail Dodge | |
|---|---|
Disabling the Rail Dodge will now cut the designs normally without being offset up and over on the mat. | |
Uncheck the Enable Rail Dodge checkbox. The design will no longer be offset on the CMC 9000 and 8000 and will cut the design normally unless values have been entered in the X Origin and Y Origin fields as described above | |
Set the Default for the Rail Dodge | |
|---|---|
The default setting for the Rail Dodge can be set in the Admin > Cutting section. | |
...
Clear Cut History Button | |
|---|---|
Use the Clear Cut History button to clear the previously cut mats from the Cut Preview Screen. | |
The previous cuts on the screen are drawn out in gray. Click the Clear Cut History button. The previous cuts on the screen are erased. This is helpful when the location of the previous cuts is a distraction, or you no longer need them as a reference when moving the location of the current design to cut. | |
Interacting Directly With the Designs on the Cut Preview Screen | |
|---|---|
See Interacting Directly With the Designs on the Cut Preview Screen for more information on manually moving designs. | |