...
Aligning the Head on the CMC 8000 | |
|---|---|
Rotate the foot block into the 12 O’Clock position. Rotate the foot block with the blade cartridge on top of the head. |  |
Holding it about an inch above the bottom rail, slide the gantry and the head assembly to the left edge of the CMC until it stops. |  |
It will stop against the Magnetic Stop. |  |
Then slide the head down until the foot block rests against the head alignment stop. |  |
Click the Align the Head button or click the Cut button to finish the Align the Head sequence. | |
Click Continue on the Align the Head screen. | |
Head will align to the home position. |  |
If you clicked the Align the Head button, the CMC is now aligned and ready to cut. If you clicked the Cut button, the CMC will now begin to cut the mat. |   |