Page Comparison

Take a small piece of matboard and draw a squiggle on the top side to indicate which side is the top.

Trim one side of this matboard using the AirGlide.

Fold the matboard in half with the top facing you, matching the ends.

Flip the mat over horizontally, and trim it again using the AirGlide.

If the top and the bottom do not match side to-side, you will need to adjust the gantry vertically.

There are four small adjustment screws at the top of the Gantry and one large tensioning screw. There are four small adjustment screws on the bottom of the Gantry.

Loosen the five screws on the top and the four screws on the bottom just enough so that the Gantry can be moved into the correct position.

Move the Gantry in the desired direction and loosely tighten the screws and do another test cut.

Repeat as necessary.

When the Gantry alignment is validated, tighten all nine screws.