Page Comparison

...

Number of Frames

Enter the Number of Frames you want to use on this project.

Enter the number of Frames desired in the Number of Frames field.

A SKU field for each frame listing is displayed where you can enter or select the SKU or select a texture for the frame layer.

You can save the texture selected for each frame layer to the associated SKU. See Save SKU Images below.

...

Set Texture

Use the Set Texture feature to create a thumbnail for the selected SKU.

Take a photo or load an image file of the moulding that you wish to use and have that image displayed on the screen.

Click the down arrow next to the desired frame layer and select Set Texture to set the frame texture.

Optionally, select Set Texture with Auto Snap if the selection is high contrast enough to allow the software to automatically snap to the top and bottom of the texture as you draw the thumbnail selection.

Click and hold the left mouse button at the upper left corner of the frame or fill sample desired.

Drag to the lower right corner of the sample, using the smallest repeatable section of the frame texture.

Release the mouse button at the right end of the desired thumbnail image.

The repeating pattern is shown on the Selection Preview at the bottom of the screen to assist with selection and rotation.

When finished, Save SKU Images for to save this thumbnail to the SKU for future reference.

Rotate Selection

Rotate the moulding selection as needed to match the frame sample by clicking on the rotation control point located off of the right side of the selection.

Hold and drag the control point up or down to rotate the selection.

Release the mouse when the selection is rotated to the desired position.

The repeating pattern is shown on the Selection Preview at the bottom of the screen to assist with selection and rotation.