Versions Compared

Old Version 1

changes.mady.by.user dani.simmonds

Saved on

compared with

New Version 2

changes.mady.by.user dani.simmonds

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

MatDesigner New Openings Screen:

Single

Array

Click Mat Design from New section of the main screen.

Click on the Array tab.

Image RemovedImage Added

Blank Mat using Default Outside Dimensions

To start with a blank mat using the default outside size, click Cancel.

OR

Go to defaults and select Skip New Openings under editor: new openings screen.

Hint: Alternately, enter desired outside dimension and click OK.

Opening Size

Enter the width/height of the opening.

  • Click Sizes to select recent or standard sizes.

  • Click Swap to switch numbers between width/height.

Image RemovedImage Added

The opening size is displayed.

Layout

Number of Openings

Enter number of openings desired.

Number of Columns

Enter number of columns to place the openings.

Number of Rows

Enter number of rows to place the openings.

Image RemovedImage Added

The layout will be adjusted.

Spacing

Enter the horizontal and vertical spacing between openings.

Image RemovedImage Added

The spacing will be adjusted.

Select Template

Click on template thumbnail under template design.

The Template Library opens.

Image Added

Click on new template thumbnail to select it.

Image Added

The new template is displayed.

Image Added

Layers

Enter number of layers, with the maximum of six layers.

Enter the reveal amount for each layer.

Image Added

Cartridge Selection

Click on the cartridge icon and select the desired cartridge for this layer.

The default cartridge is the 45° cartridge.

Click RB (Reverse Bevel) checkbox to make the layer a reverse bevel.

NOTE: Cartridges not currently available will be greyed out.

Image Added

The Editor